modern flute C foot

C#6

Conventional Fingering

Impedance

Fingering a key depressed a key not depressed a part of the mechanism that is not normally touched Details in fingering legend. Acoustic schematic a closed tone hole an open tone hole Non-specialist introduction to acoustic impedance Non-specialist introduction to flute acoustics

From E4 to C#5 and E5 to C#6, each standard fingering serves for two notes. The flutist uses the same fingering for C5 and C6, but changes the speed, length and shape of the jet. The first three minima can be played. This note is acoustically different because the highest tone hole opened is smaller than the other tone holes (not counting the two trill/register keys). This is because it also serves as a register hole for D5, D#5, D6 and A6. The latter use largely determines its position, and its size is chosen to tune C#. The acoustic difference in this note is enhanced by its being the last note below the change in register: compare the impedance spectrum with that for D6.

Impedance

Fingering a key depressed a key not depressed a part of the mechanism that is not normally touched Details in fingering legend. Acoustic schematic a closed tone hole an open tone hole Non-specialist introduction to acoustic impedance Non-specialist introduction to flute acoustics

Comparing with the standard fingering, one sees that the effect of closing a hole downstream from 10 open holes is very small at frequencies below the tone-hole filtering limit of about 2.5 kHz, but that there are discernible differences at higher frequencies.