Acoustics of the saxophone

Bb tenor saxophone

F5

Music Acoustics UNSW

Conventional Fingering

Impedance

Fingering
a key depressed
a key not depressed
a hole covered
a hole uncovered
a part of the mechanism that is not normally touched
Details in fingering legend.

Acoustic schematic
a closed tone hole
an open tone hole

Non-specialist introduction to acoustic impedance
Non-specialist introduction to saxophone acoustics

Notes are the written pitch.
Frequencies are the sounding frequency, for Bb saxophone.
Unless otherwise stated, the impedance spectrum is for a Bb saxophone.


Impedance spectrum of a Bb tenor saxophone measured using fingering for F5.

This is the fourth note in the second register. It differs from F4 (the corresponding note in the first register) in that it uses a register hole. This causes a leak in the bore that weakens the first impedance peak, but has little affect on higher peaks – see register hole for an explanation, and compare with F4, whose impedance spectrum is almost identical except for the first peak. Above about 1 kHz, the curve is irregular: see the discussion in cut-off frequency.

Compare with the impedance spectrum for a soprano sax on written F5: same fingering but sounding one octave higher.

Sound


Sound spectrum of a Bb tenor saxophone played using fingering for F5.
For more explanation, see Introduction to saxophone acoustics.

This sound spectrum includes transient excitation from the beginning of the note, and so has traces of a subharmonic being excited, seen in the range above 4 kHz (compare F4).

Sound Clip

You can hear F5 played.


Fingering legend
How were these results obtained?

Contact: Joe Wolfe / J.Wolfe@unsw.edu.au
phone 61-2-9385-4954 (UT +10, +11 Oct-Mar)
© 1997-2009 Music Acoustics UNSW